FAST GRUNT S-T Priming mortar for silicate plasters, based on water glass
A primer for silicate plasters based on water glass
FAST GRUNT S-T is a ready-to-use, well-covering, quartz-containing primer for silicate plasters. Thanks to its properties, it is necessary for priming all concrete, ceramic and cement-lime surfaces that will be covered with plaster. It can only be used outside the building. FAST GRUNT S-T is a component of the FAST S and FAST W thermal insulation system.
FAST GRUNT S-T under plasters is characterized by an excellent adhesion, good coating and high penetration ability. It is water- and frost-resistant, vapor-permeable, reduces the absorbency of the surface and causes optimum adhesion of the topcoat. Resistant to alkali. It is supplied in a rich palette of colors according to FAST COLOR SYSTEM.
a bucket - 6.4 kg
a bucket - 16 kg
Preparation of the surface
The surface should be even, strong and dry, free from all kinds of impurities that reduce the adhesion of the expedition, ie dust, lime, grease, and remains of old paint coatings. In case of weak, very absorbable or scattering surfaces, the surface should be primed with FAST GRUNT S for diluting paints.
Preparation and use
Apply FAST GRUNT S-T under the plaster on a previously prepared, primed and dry surface with a brush or roller. It is allowed to dilute with a small amount of water (up to 5%). Work should be carried out at + 8 ° C up tp + 25 ° C. Plastering can be started no sooner than after 24 hours from the application of the mortar.
Base unit: kg
Base: water dispersion of potassium glass and acrylic resins
Operation: after min. 24 hours
Substrate and ambient temperature: from +5 to +25 degrees Celsius
VOC content: below 30 g / l
Bulk density: about 1.6 kg / dm3
Storage and comments
Store in tightly closed containers at temperatures between + 5 ° C up to + 25 ° C.
The recommended scope of use of the product or the method of application does not relieve the contractor from carrying out work in accordance with the construction works and health and safety rules.
P.W. FAST guarantees and bears responsibility for the quality of the product, while it does not affect the way it is used and the conditions in which it was used. All technical data were measured under normal conditions, i.e. at + 20 ° C and 60% relative humidity. In case of other conditions than the above, the drying time may change, i.e. lengthen or shorten.
This card replaces all previous versions.
During work, avoid direct contact with the skin and protect the eyes. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Immediately wash contaminated skin with plenty of water. Keep away from children.
The product conforms to the European Technical Approval: ETA-14/0464 and ETA-14/0465. It has the ETA certificate of conformity: 1020-CPR-020-032349 and 1020-CPR-020-032351. It has a valid hygienic certificate. The component of the ETICS FAST S and FAST W thermal insulation system.