FAST GRUNT-S a water glass based primer for silicate paints 5L

Availability: dostępny na zamówienie
Dispatched within: 5 dni
Price: 55,00 zł 55.00
quantity szt.

product unavailable

add to wish list
Rating: 5
Vendor: FAST
Product code: GRUNT-S (pod farby) 5L


a primer based on water glass, for silicate paints
FAST GRUNT S is intended for priming mineral surfaces, such as cement, cement-lime plasters and thin-layer mineral plasters. It is also used for priming of raw surfaces made of concrete, as well as bricks, blocks, airbricks and other such ceramic or lime-sand materials. It also serves as a diluent for silicate paints.

FAST GRUNT S strengthens the surface and evens out its absorbency. It helps to perform paint coatings and improves their adhesion. It also reacts chemically with the surface, penetrating its structure. Colourless after drying. Intended only for outdoor use.
a container - 5 liters
Preparation of the surface
The surrface should be dry, stable, strong and cleaned of layers that may weaken the adhesion of the ground, especially of dust, dirt, wax and fats. Old, poor quality paint coatings and other layers with poor adhesion to the substrate, as well as coatings made of dispersion paints should be carefully removed to obtain clean mineral surfacee, small damages and cracks should be repaired and refined. New plasters can be primed after they have dried, but not earlier than 3 days.
Preparation and use
FAST GRUNT S is a ready to use preparation. Mix the contents of the package before use. The mixture cannot be diluted. Apply the primer evenly to the surface using a brush or roller. Highly absorbable surfaces should be primed again after 2-3 hours. Apply paint on the primed surface after at least 24 hours. Do not carry out work on rainfall, strong wind and high insolation. Protect against rain, frost and quick drying. Clean the tools with clean water immediately after use before the surface dries. The use of gloves, goggles and protective clothing is recommended.
Technical data
Base unit: liter
Base: dispersion of potassium water glass
Drying time: up to 3 hours
Operation: after min. 24 hours
Substrate and ambient temperature: 5 to 25 ° C
VOC content: below 30 g / l
Bulk density: about 1.0 kg / dm3
Storage and comments
The product should be stored and transported in tightly closed packaging at a temperature of + 5 ° C up to + 25 ° C.
The recommended scope of use of the product or the method of implementation does not relieve the contractor from carrying out work in accordance with the construction arts and health and safety rules.
P.W. FAST guarantees and bears responsibility for the quality of the product, while it does not affect the way it is used and the conditions in which it was used. All technical data were measured under normal conditions, i.e. at + 20 ° C and 60% relative humidity. In the case of other conditions than the above, the drying time may change, i.e. lengthen or shorten.
This card replaces all previous versions.
During work, avoid direct contact with the skin and protect the eyes. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Immediately wash contaminated skin with plenty of water. Keep away from children.
The product conforms to the European Technical Approval: ETA-14/0464 and ETA-09/0465 The product conforms to the ITB Technical Approval: AT-8869/2012 + Annex 1 It has the certificate of conformity: ITB-526 / Z Has the ETA certificate of conformity: 1020-CPR -020-032349 and 1020-CPR-020-032351 Has a valid hygienic certificate. The component of ETICS FAST S and FAST W. thermal insulation system.

Product reviews (0)

Shop is in view mode
View full version of the site
Sklep internetowy